Why are my ears ringing? It is possible that the noise level of a 2 hp or 3 hp high performance blender can damage your hearing? Children have been particularly sensitive to high noise levels. Our research has helped us understand that many parents send their children out of the kitchen or into the room and shut its door when they attempt to blend a smoothie or a raw soup.
It has turned out, because of the unpleasant noise levels as high as 105 dB high-performance mixer, as consumers mix less frequently and for shorter mixing cycles. This means that if it were not for the noise as a 2 hp or 3 hp blender produces, consumers would actually blend their soup all 4 to 5 minutes instead of just 30 seconds to a minute, and then heat it up in other ways. This also means that instead of a smoothie mixed thoroughly full 25 plus seconds, consumers cut it short for 10 seconds. They rather take their smoothies in thicker form than in fine-blended improved nutrition.
We compare the noise of the Vita Mix 2 hp 5200, 4500 turbo blender, the 3 hp Vita Mix Vita Prep 1005 blender, Blendtec EZ, HP3A and total Blenders, and Waring Blenders, some among many other commercial blenders:
1. Blendtec HP3A, Total Blender, EZ Blender - noise level varies from 92 dB to 98 dB
2. Connoisseur Blendtec Blender - noise level varies from 95 to 102 dB
Three. Smoother 20 AMP ICB 7 Blender - noise level varies from 98 dB to 105 dB
4. Vita Mix 4500 Turbo and Vita Mix 5200 2 hp blenders - the noise level varies from 90 dB to 95 dB
5. Vita Mix Vita Prep 1005/3 hp blender - the noise level varies from 95 dB to 98 dB
6. Waring 3.5 hp Blenders - noise level varies from 90 dB to 98 dB
7. Montel Health Master 1.75 hp 1.85 hp - noise level varies from 89 dB to 92 dB
Residential and semi-commercial / residential Blenders coming today with audio attachments are:
1. Blendtec Smoother 13, 15, 18, and 20 amps
2. Blendtec ABC 13, 15, and 20 amps
3. Waring MX1500XT
Vita Mix Corporation produces a Whisper Sound Enclosure for $ 200 + dollars available. Typically all sound enclosures for blenders costs about $ 200 + dollars. The market requires, because of the noise canceling interests especially in the residential arena, to cost under $ 100 dollars. It is a difficult task to achieve.
We have found that the material costs of cell-cast acrylic 3/16 inch, when purchased in large quantities, for a sound enclosure that fits Blendtec HP3A, Total Blender, and EZ blender, and Vita Mix Series 4500 Turbo Blender, Vita prep 2 hp and 3 hp blenders, and the two hp Vita mix 5200 blender average about $ 40 dollars. Normally labor for assembly takes another $ 30 to $ 40 dollars. For companies that want to sell a sound enclosure under $ 100, it's hard to make a profit. And to build an even being put into question here whether it can be cost effective.
Consumers have indicated that they were interested in building their own to save money. When purchasing materials, need a single consumer to buy more material than necessary. So the final material cost is around $ 60 dollars. Materials must be cut and the waste is quite large. And solvents to glue the components together properly is potentially dangerous if not cared for or used correctly. And if the consumer sound enclosure enthusiast does not have the correct table so right $ $ 150 special acrylic material blade, the material can be cut uneven and could chip.
The solvent amount to bind the wrists for a sound enclosure is less than one / half liquid ounce while the consumer has to buy an amount that will build 40 good enclosures. Setting a sound enclosure together takes an experienced person about 15 minutes. An amateur will probably require around 1 to 1.5 hours.
Additionally, most of the time a consumer at least some previous experience with cell-cast acrylic bonding before a sound enclosure is nicely put together. And nicely means that it does not look ugly and it will hold up. It is very easy to spill solvent on acrylic sheet and some stains are permanent. After all, a consumer would see his / her sound enclosure on a daily basis. An ugly amateur piece will be a constant reminder of an inability to build a strong cabinet.
This being said, it certainly raises the question whether it is really worth it to have a sound enclosure, unless it is an already pre-made in a price range far below $ 100 dollars. The market demands it. Tens of thousands of people in the US alone already own a high-performance blender from brands like Waring, Vita Mix and Blendtec or Health Master.
It's just a matter before someone jumps on the idea of ??creating a blender sound enclosure box that works and costs about $ 60 to $ 80 US dollars teapot. And it would of course be nice if the practical men sound enclosure enthusiasts who want to build s.